Complete revision set for the fork swingarm of the Vespa Wideframe models (from approx. 1952) as well as the Largeframe models with 8 inch tires (until approx. 1966). Therefore suitable for e.g. Vespa Wideframe VM, VN, VL, VB, GS150 / GS3, Largeframe VNA1T-VNA2T, VNB1T-VNB5T (-026920), VBA1T, VBB1T, VBB2T (-212455), GL15 (VLA1T -067469)
The set contains all parts needed for a complete overhaul, except brake pads and lubricants (see accessories).
TECHNICAL UPGRADE
Compared to the factory design, the set contains a double-encapsulated ball bearing on the wheel side. This is provided with a lifetime grease filling.
The use of an encapsulated bearing has several advantages:
- The shaft sealing ring is omitted ->less friction
- No grease can get into the brake (if the shaft seal is defective)
- The bearing cannot run dry
On the swing arm side we use a ball bearing with slightly increased lateral clearance (C3). This allows the front wheel axle to run smoothly without play. The bearing clearance allows a tension-free assembly of the axle. If, like the original, a bearing without clearance is used, the axle will always jam slightly and increase the rolling resistance as well as the load on the bearing considerably.
SCOPE OF DELIVERY
- 1x circlip -bore DIN472- Ø=40mm (used for wheel bearing in swing arm)
- 1x ball bearing with C3 clearance, used for front wheel axle/swing arm
- 1x ball bearing (encapsulated on both sides) used for front wheel axle/swingarm
- 1x nut front wheel axle right (swingarm side) SW22, H=8,7mm (for fork/swingarm)
- 1x spacer washer for bearing front wheel axle 34x26x3mm – (for fork/swingarm)
- 1x washer – sealing ring swingarm bearing axle, brass with felt ring- Vespa Wideframe – Ø=12mm
- 1x safety cap – nut front wheel bearing -VESPA, fine thread until year 1962
- 1x swingarm bearing set incl. bolts, needle bearings, spacers
- 1x speedometer worm set Vespa 11 teeth, l=44mm, 2,7mm square
- 1x spring bracket set (incl.spring plate and grease nipple) for shock absorber spring front, lower fork/swing arm
- 1x washer for swingarm bearing inside, Ø=12mm
- 1x nut -DIN 934- M10 x 1,5
- 1x Brake shoe lock
- 1x BGM Pro bolt set for front shock absorber (bolt below incl. snap ring and nut, bolt above incl. snap ring)
- 1x Spring plate for front shock absorber spring, upper fork/swing arm
AI-translation
Reviews
There are no reviews yet.